Returning Customer
I am a returning customer
Register Account
If you already have an account with us, please login at the login form.
Your Account Has Been Created!
Congratulations! Your new account has been successfully created!
You can now take advantage of member privileges to enhance your online shopping experience with us.
If you have ANY questions about the operation of this online shop, please e-mail the store owner.
A confirmation has been sent to the provided e-mail address. If you have not received it within the hour, please contact us.
Account Logout
You have been logged off your account. It is now safe to leave the computer.
Your shopping cart has been saved, the items inside it will be restored whenever you log back into your account.
Before use need to lift the table on the height of the mechanical rail has no offset change.
You need to regularly clean the field lens, you can use the rag with a small amount of alcohol before cleaning, pay attention to rub in one direction.
The laser inside the box to clean, you can use the air gun blowing along the duct, while cleaning the chassis inside the relevant circuit board.
Check the software before boot boot settings are changed.
According to the steps required to switch on and off.
The host computer, keyboard pay attention to clean.
Button check to see whether the indicator light is normal.
Regularly check the fan operating conditions, to correct the fan is not working properly.
The use of shut down after the timely removal of rubbish, special marking material residue or metal powder, clean the surrounding health, to maintain ventilation.
Precautions
Laser air-cooled laser, the working environment (room temperature) temperature at 10 ℃ -35 ℃ (25 ℃ best)
Do not bend the fiber, if you need to bend, to ensure that the smallest diameter of the fiber bending diameter greater than 20 cm
Abnormal phenomenon, first turn off the laser power and galvanometer power, check again