1.Make Cooling system to be grounded,cleaning the water tank and aquage frequently, cooling control tank temperature need to be suitable,otherwise it will cause the laser tube easily broken and condensation power down,tube cold head will fall off,work life will greatly be shortened,sometimes unable to work Constantlyand need to changing tube.

2.For Laser cutting machine, installation of laser tube fulcrum should be reasonable,the fulcrum should be in the v of laser tube total length,or it will cause the laser tube spot pattern deterioration,some machine the spot becomes a few points after work for a time, and resulting in laser power drop down and can not Meet the requirements, resulting change tube in continuous.

3.Water protection should always check the cleaning,cooling water can not open water protection Float switch or water protection Float switch is not reset,then it can not use short-circuit method to solve urgent needs.

4.Breathing device should be checked on time to clean up the fan duct,otherwise a lot of smoke and dust could not row out,it will have a bad influence on lens and laser tube severely and rapidly,so that the mechanical and electronic components will be oxidized,then the contact is will not be good.

5.Focus lens and mirror inspection,frame temperature will be high even you just use it for a while,surface color of lens will be rusted.if stripping cracking,you should replaced the stripping,especially many customers use air pump and air compressor,in this way,the focus lens will have water soon,it is necessary to check the  cleaning and quality of lens light system on time,make sure everything goes well.

6.Laser cutting machine working environment can not be too bad,if the ambient temperature is higher than 30 degrees or less than 18 degrees,if it has too much dust, or air pollution,in such bad conditio, machine damage rate will be increased,work failure rate also rising; and the spare parts for laser cutting machine also easy to go wrong.

7.To match the power of the grid.

8.Laser tube working electric current should be suitable,can not be long-term in the 90-100 light intensity work;reasonable application of laser and save laser energy;optical system need be clean and accurate otherwise it will cause the laser tube premature aging and rupture, so laser machine work Time should be adjusted in 50-60%,and then adjust the work  speed based on different material,this is the best working condition for the laser tube.

Hope this article is helpful for you when you use the laser cuttting machine.

By the way,if you are interested in laser cutting machine,welcome to check the link below:

http://www.raymondcoding.com/laser-marking-machine